Categories

False alarms and system malfunctions can be aggravating, and even worse, could prevent your home’s security from doing its job effectively. Luckily, most problems, from dead batteries to false alarms, are easy to fix. Explore our suggestions for troubleshooting your home alarm system in Eau Claire. We’ll help keep your household shielded and your system running as it should.

Test Your Home Security System In Eau Claire

One sensible way to troubleshoot your property’s defense is to test it! Modern systems have a test mode so you don’t accidentally prompt an emergency call. After switching to test mode, take these steps:

• Turn on your system as you would when going out.
• Open a door or window protected by a contact sensor, or try to trigger something else. Shut the door or window once you’re done so it doesn’t trigger the alarm as you reactivate the system.
• Permit the alarm to resonate for 60 seconds to ensure communications with the security company and to create an entry in the alarm system log.
• Proceed to test devices as you wish
• Check the alarm’s activity log to verify functionality.

Rest assured, monitoring specialists will be able to see that your alarm system is involved in a test. Just make sure to turn test mode off when done. It’s wise to test monthly or anytime you change your home’s phone or internet service.

Check The Placement And Condition Of Motion Sensors

Although an crucial part of your alarm system, motion sensors are notorious for false alarms. You can help prevent them with some simple troubleshooting.

• Conduct a visual inspection. Is there anything that could shift within the detection path of the sensor, like a curtain caught in a breeze?
• Is the sensor clean? Grime, dirt, and cobwebs can lead to malfunctions. Make sure the sensor is clean.
• Does the motion detector offer pet immunity you can turn on? Some sensors can be programmed to disregard pets up to 100 pounds.
• When was the battery replaced? Low batteries may affect performance or cause false alarms.
• Is a heat source affecting the sensor? Excessive heat from a fireplace, direct sun, or something else can trigger an alarm.

Keep Batteries Ready And Pay Attention To Low Battery Signals

One helpful perk of the latest home security systems is that they’ll tell you when batteries are getting low. If your system uses a control panel or app, you’ll usually find notifications there. Depending on your alarm, you might hear an intermittent beep when batteries are low. 

Contact sensors, motion detectors, smoke detectors, and other wireless devices have batteries that need to be replaced every 1 to 2 years. It’s best to keep batteries around and set a replacement schedule. Some systems also come with a backup battery for the primary control panel. This battery keeps your system functioning if you lose power and should recharge once the electricity is working again. If it fails to recharge, you will need to replace it.

Troubleshooting Is Easy With ADT Home Security In Eau Claire 

As the top name in home security, ADT creates systems that offer unsurpassed protection and functionality. Getting into test mode is straightforward through MyADT.com or the ADT+ app, and you’ll always be sent alerts when a sensor battery is low. Reach out to Secure24 Alarm Systems, an authorized ADT dealer, to find out more and design a system perfect for your Eau Claire home. Dial (715) 255-6964 or complete our form today!